Saber R33CC0312 Instrucciones De Montaje página 5

Procedure - Removing the Existing Control Panel
In this step you will disconnect the Ignitor Wires and
7
Light Switch Wires (if equipped) from the Control Panel.
NOTE - Be sure to hold the Control Panel in place while
•
removing the Wires. Once all Wires are removed, the Control
Panel could fall if it is not supported.
On the left hand side - Hold the Switch to prevent damage.
•
Pull both Wires loose from the Switch.
On the right hand side, first bend up the flap on the Heat
•
Shield as shown. Then pull the red and black Wires loose
from the Switch. Take note of the proper location for the
Wires for reassembly. This is shown below.
Once you have the Control Panel disconnected, remove it
•
from the Grill and set it aside.
Take care while removing the Side Burner Quick-Connect (if
•
equipped) and Hose and Regulator from the Grill to prevent
damage to other Grill Components.
Left Hand
Side
© Saber Grills, LLC
All manuals and user guides at all-guides.com
Black Wire
5
Right Hand
Side
Black Wire
Red Wire
Rear
of
Switch
Not Used
80028080 ● 09/13/17 ● Revision 03
Printed in U.S.A.
Heat Shield is
shown transparent
Black Wire
Red Wire
sabergrills.com