Saber R33CC0312 Instrucciones De Montaje página 8

Procedure - Installing the new Control Panel
Remove your Cooking Grates for this step.
•
14
Insert your Thermometers, one at a time into the
•
Control Panel.
Engage the tabs into the Control Panel slots, then
•
press down on the top of the Thermometer to snap it
into place.
Repeat this step for each Thermometer on your Grill.
•
1
If your Grill DOES NOT have a Side Burner - you are almost done. Please skip to Page 11 and perform the leak check
procedure.
If your Grill DOES have a Side Burner we need to show you how to replace it.
You will recall from Step 5 that you disconnected the Side Burner Quick-Connect fitting - leave it disconnected.
Please note that the Side Burner lid will not be shown for clarity.
Tools and Safety Equipment Recommended -
NOTE: Some Tools are not included. You will need the 7/16" socket tool (included) to complete the replacement of the Side
Burner. This Tool is needed only for the replacement of the Side Burner. Wear Gloves to protect your Hands during the
replacement procedure.
Small bucket or cup
7/16" Socket
Tool (Included)
Procedure - Replacing your Side Burner - Side Burner Removal
You will begin the Side Burner replacement procedure by removing the old Side Burner.
1
At this point - you should have previously disconnected the Quick-Connect fitting and removed the Control Knobs and
Bezels.
First - remove the Side Burner Grate.
•
Next - unplug the Ignitor Electrode Wire from the
•
Side Burner Electrode by hand. You may need to
hold the Electrode with one hand while pulling the
Wire away with the other hand.
© Saber Grills, LLC
All manuals and user guides at all-guides.com
2
!!
The tip must be visible!
Liquid Soap
Soft Bristle Brush
3
Control Panel
Side Burner Replacement
Phillips Screwdriver
8
80028080 ● 09/13/17 ● Revision 03
Printed in U.S.A.
These symbols mean to use
caution and to wear your Goves.
sabergrills.com