Dometic Travel Power 3.5 Instrucciones De Uso página 19

Dometic Travel Power
The electrical box indicates operating modes and errors (e.g. low or high
speeds, overload) on the LEDs.
Travel Power delivers a sine wave voltage of 230 Vw/50 Hz. The frequency
is not dependent on the engine speed however the power loading is.
Depending on the vehicle engine speed, Travel Power delivers constantly a
current up to
 Travel Power 3.5: 16 A
 Travel Power 5.0: 25 A
 Travel Power 8.0: 36 A
Travel Power functions by means of a battery:
 Travel Power 3.5 – 5.0: 12 V battery (cars) and 24 V battery (trucks)
 Travel Power 5.0 ASC: only 12 V battery (cars)
 Travel Power 8.0 W: only 24 V battery (trucks)
8.2 Displays and control elements
Displays see fig. 4, page 4
LED Colour
RPM High yellow
ON green
RPM Low red
Alarm red
Overload yellow
Control elements see fig. 3, page 4
No. in
Description
fig. 3, page 4
5 On/Off-switch
EN
Description
Engine speed too high for the needed electrical power
Flashing: ready (no engine speed)
Constantly lit: 230 V available
Engine speed to Iow for the needed electrical power
Slowly flashing: Temperature protection active
Constantly lit: High/low voltage protection active
Constantly lit: Short circuit
Protection limit of current exceeded
Technical description
19