Using Travel Power - Dometic Travel Power 3.5 Instrucciones De Uso

Dometic Travel Power
10

Using Travel Power

10.1 Precautions before starting Travel Power
➤ Before switching on the power box please check:
– that appliances not intended for use are turned off or disconnected
– that the engine is correctly running
(if not: the green LED is flashing)
– that the requested/needed electrical power is adequate for the nominal
Travel Power output
(if not: the power box starts with auto-protection, the red LED is
continuously lit)
– that the alternator's revolutions are adequate for the requested
electrical power
(if not: the power box starts with auto-protection, the red LED is
continuously lit)
10.2 Starting Travel Power
➤ Switch on the power box (fig. 3 5, page 4).
➤ Check the LEDs of the power Box (see chapter "Displays and control ele-
ments" on page 19).
➤ When the green LED is continuously lit switch on the electrical load
according to the nominal load and the correspondent alternator's speed.
See the following graphics:
– 3.5 kW: fig. 6, page 6
– 5 kW and 5 kW ASC: fig. 7, page 6
– 8 kW: fig. 8, page 7
If the green LED is not continuously lit see chapter "Troubleshooting" on
page 22.
10.3 Shutting down Travel Power
➤ Turn off all appliances which shall not restart automatically when Travel
Power will be switched on again.
➤ Switch off the power box (fig. 3 5, page 4).
EN
Using Travel Power
21