Spare Parts; Cleaning - Küschall CHAMPION Manual Del Usuario

Champion
7. Lift the tire wall over the edge of the rim. Start close to the
valve and use a bicycle tire lever. When doing this, check all
the way round to ensure that the inner tube is not trapped
between the tire and the rim.
8. Inflate the tire to the maximum operating pressure. Check
that no air is escaping from the tire.

Spare parts

All spare parts may be obtained from a küschall®
specialist dealer. A current list of spare parts is available
on the internet at www.kuschall.com.

8.3 Cleaning

Your wheelchair will serve you well for many years if you clean
it regularly.
IMPORTANT!
Sand and seawater can damage the bearings and
steel parts can rust if the surface is damaged.
– Only expose the wheelchair to sand and
seawater for short periods and clean it after
every trip to the beach.
IMPORTANT!
– Do not use coarse abrasives, aggressive cleaning
products or high-pressure cleaners. Never use
acids, alkalines or solvents such as acetone or
cellulose thinner.
– Always use ordinary household cleaning agents.
36
1. Clean the cushions and metal parts with a soft, damp cloth.
2. Dry the wheelchair carefully with a cloth after using it in the
rain.
3. If the wheelchair is dirty, wipe off the dirt as soon as possible
with a damp cloth and dry it carefully.
Regular cleaning will reveal loose or worn parts and
enhance the smooth operation of your wheelchair. To
operate properly and safely, your wheelchair must be
cared for just like any other vehicle. For upholstery that is
severely stained or surface finish that is badly damaged,
contact an authorized dealer for further information.
Cleaning upholstery
For cleaning upholstery refer to the instructions on the label on
the seat, cushion and backrest cover.
Cleaning metal surfaces
Hot water and mild detergent on soft cloth should be use to
cleaning metal surfaces.
1. Wipe down with damp cloth.
2. Dry surface by wiping down with dry cloth.
Car polish and soft wax can be used to remove abrasions and
restore gloss.
Cleaning plastic surfaces
Plastic surfaces must be cleaned with soft cloth, mild detergent
and hot water.
IMPORTANT!
– Do not use solvents or kitchen cleaners to clean
plastic surfaces.
1. Rinse surface with clean water.
2. Dry surface by wiping down with dry cloth.
1583536-C