Mounting The Luminaire Of Mounting Type "Adjustable Holder - Lunux IL UP Instrucciones De Montaje

Mounting
3.3 Mounting the luminaire of
mounting type "Adjustable
holder"
In combination with the adjustable holder,
the luminaire is ball-impact-resistant
according to DIN 18032-3.
Fig. 4: Hole pattern.
X Mount the holder to the wall or ceiling
using suitable screws, see Fig. 4.
C
Fig. 5: Mounting the adapter plate
X Screw the adapter plate B to the inside
of the holder using hexagon screw C
and hexagon nut A, see Fig. 5.
X Mount the second adapter plate to the
other inside of the holder.
Fig. 6: Hanging the luminaire into the holder
X Hang the luminaire into the holder, see
Fig. 6.
S-MA IL Up_00_405424811.indb 21
E
Fig. 7: Hanging the retaining plate into the
luminaire
X Hang the retaining plate E into the lu-
minaire, see Fig. 7 .
X Screw the screw D into the adapter
plate.
X Hang the second retaining plate into the
luminaire on the other side.
X Screw the second screw into the sec-
ond adapter plate and tighten both
screws D to a torque of 15 – 20 Nm.
A
B
Fig. 8: Aligning the luminaire
X Align the luminaire, see Fig. 8.
Fig. 9: Tightening the hexagon screws
X Tighten the hexagon screws C to a torque
of 50 Nm on both sides of the luminaire,
see Fig. 9.
ENG
1.
2.
D
+
90°
-
C
21
13.06.2017 07:41:00