Connection; Connecting The Luminaire Without Plug-In Connector; Connecting The Luminaire With Plug-In Connector - Lunux IL UP Instrucciones De Montaje

ENG
4.

Connection

NOTICE
Material damage caused by wrong
mains voltage.
Damage or destruction of the luminaire.
X Connection by a skilled electrician
only.
X Compare the mains voltage with
the nominal voltage and the fre-
quency specified on the rating
plate and make sure that they are
identical.
4.1 Connecting the luminaire
without plug-in connector
Colour of the
wire
brown
black
grey
blue
yellow/green
Tab. 2: Terminal assignment with "DALI CLO",
"DALI" or "1-10 V" activation.
Colour of the
wire
brown
blue
yellow/green
Tab. 3: Terminal assignment with "On/Off" acti-
vation.
NOTE: Observe the terminal assignment,
see Tab. 2 and see Tab. 3.
X Connect the wires to a suitable power
supply.
22
S-MA IL Up_00_405424811.indb 22
Assignment
L1
DALI / +
DALI / -
N
PE
Assignment
L1
N
PE
4.2 Connecting the luminaire
with plug-in connector
Designation Specification
Cable type Flexible cable
Number of wires 3 / 5
Cable cross-sec- 0.75 - 4 mm²
tion (per wire)
Diameter of 10 - 14 mm
sheathed cable
Sheath stripping PE: 30 mm
length N, L, Dali: 25 mm
Wire stripping 8 mm
length
Tab. 4: Required cable.
X Determine the socket assignment
according to the following table.
A
E
D
No. Assignment
A
PE
B
L
C
DALI / -
D DALI / +
E N
Tab. 5: Socket, view from behind.
X Connect the cable to the socket.
X Connect the socket to the plug on the
luminaire.
Connection
B
C
13.06.2017 07:41:00