GE Arize H1000 Guia De Instalacion

Arize™ H1000/600 Luminaire
Horticulture Lighting System
Installation Guide
English (EN)
WARNING & CAUTION
Turn power off before installation, inspection, cleaning or removal.

Properly ground electrical enclosure.

This product must be installed in accordance with the applicable installation code by a person familiar with

the construction and operation of the product and the hazards involved.
Use only with components identified in this document.

 Do not expose lamp to water. The lamp may shatter and cause injury.
Wear suitable Personal Protective Equipment (PPE) during installation/maintenance.

 Luminaire design for Greenhouse only. Not suitable for household illumination.
Suitable for operation in an ambient temperature between -20° C and 40° C.

Shipping & storage between -40° C and 70° C, non-condensing.

Do not keep combustible materials below lamp.

Do not turn on lamp until fully installed.

Do not look directly at the operating lamp for any period of time, this may cause eye injury.

This device complies with CE-EMC Directive 2014/30/EU. This product may cause interference to radio

equipment and should not be installed near communication equipment operating between 0.45-30 MHz.
Modifying or opening the system will void the warranty.

 The green LED indicator is designed to help troubleshoot minor issues with the ballast. Contact GE Current
if need further information.
 If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
RISK OF FIRE - Only use lamps specified on the luminaire.

RISK OF FIRE - Make sure the lamp-holders are clean and in good condition, replace new one when

needed. Affix the lamp securely in the socket. Improper installation will cause electrical arcing, overheating,
and short life to lamp and socket.
RISK OF BURN - Allow lamp and reflector to cool before handling.


RISK OF INJURY - Do not use lamp if outer glass is scratched or broken.

RISK OF INJURY - Do not use excessive force when installing lamp.

Never bend the lamp wires. Always use a fabric glove to handle the lamp and reflector.

It is recommended to replace the lamp at L90, and the reflector after two to four years depending on the
environment and contamination levels.
WIRING DIAGRAMS:
220/230/240V
OPTICS
:
OPEN REFLECTOR (0-180°)
List of Components
1
Ballast
2
Lamp Holder
3 Reflector Option
4
Mounting Options
5 Bracket
1
400V
CYLINDRICAL REFLECTOR (0-180°)
4
5
1
2
3