Cleaning And Maintenance; Replacing The Filters; Protecting The Environment - Black and Decker V1250 H1 Manual Del Usuario

ENGLISH
V1250/V9650
Two additional accessories are stored in a
portable caddy located in the charging base:
a soft brush (8) for keyboards and
u
lamp shades
an extendable crevice tool (9) for
u
longer reach in confined spaces
V1250N
This model is not supplied with accessories.
To fit an accessory, proceed as follows:
Take the accessories from the
u
appliance.
Insert the appropriate accessory into
u
the front of the appliance.

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(fig. F & G)
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and
u
remove the dust bowl (3).
Empty the dust bowl.
u
Remove the filters (10) by twisting
u
them clockwise.
Brush any loose dust off the filters.
u
Wash the filters in warm, soapy
u
water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.
Make sure the dust bowl and filters
u
are dry.
Refit the filters (10) onto the appliance,
u
twisting them counterclockwise until
they lock into place.
Refit the dust bowl onto the
u
appliance. Make sure the dust bowl
clicks into place.
Warning! Never use the appliance
without the filters. Optimum dust
collection will only be achieved with clean
filters and an empty dust bowl.
Replacing the filters
The filters should be replaced every 6 to
9 months and whenever worn or
damaged. Replacement filters are
available from your Black & Decker
dealer (cat. no. VF20).
6
Remove the old filters as described
u
above.
Fit the new filters as described above.
u
Maintenance
Your tool has been designed to operate
over a long period of time with a
minimum of maintenance. Continuous
satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any
maintenance, switch off and unplug the tool.
Switch off and unplug the
u
appliance/tool.
Or switch off and remove the battery
u
from the appliance/tool if the appliance/
tool has a separate battery pack.
Or run the battery down completely if
u
it is integral and then switch off.
Unplug the charger before cleaning it.
u
Your charger does not require any
maintenance apart from regular
cleaning.
Regularly clean the ventilation slots in
u
your tool using a soft brush or dry cloth.
Regularly clean the motor housing
u
using a damp cloth. Do not use any
abrasive or solvent-based cleaner.
Regularly open the chuck and tap it
u
to remove any dust from the interior
(when fitted).

Protecting the environment

Z
Separate collection. This
product must not be disposed of
with normal household waste.
Should you find one day that your
Black & Decker product needs replacement,
or if it is of no further use to you, do not
dispose of it with household waste. Make
this product available for separate collection. z
Separate collection of used
products and packaging allows
materials to be recycled and
used again. Re-use of recycled
materials helps prevent
environmental pollution and
reduces the demand for raw
materials.