When The Work Is Done; Emptying The Dust Container - Bosch GL-40 Instrucciones De Uso

en
11
Figure
Remove the upholstery nozzle and crevice nozzle
from the accessories holder as illustrated.
12*
Vacuuming with accessories
Figure
Attach the nozzles to the tube or handle as required:
a)Crevice nozzle for vacuuming crevices and corners,
etc.
b)Upholstery nozzle for vacuuming upholstered furni-
ture, curtains, etc.
c) Hard furnishings brush for cleaning window frames,
cabinets, mouldings, etc.
13
Figure
After use, push the crevice nozzle and upholstery
nozzle back into the accessories holder as indicated.
14*
Figure
Secure the drill dust nozzle to the handle and then place
against the wall, so that the nozzle drill hole opening sits
directly over the hole to be drilled.
Select the lowest power setting and then switch on the
vacuum cleaner.
Suction holds the drill dust nozzle in the required posi-
tion.
Depending on the surface of the wall to be drilled it may
be necessary to readjust the power to a higher setting to
ensure the drill dust nozzle is firmly attached.
Any fine particles are automatically vacuumed up.
Caution: the drill dust nozzle should only be used in
!
conjunction with the dust container since fine drill
dust can impair the function of the dust bag.
Hard-floor brush
15*
Figure
For vacuuming hard floor coverings (tiles, parquet
flooring, etc.)
Push the telescopic tube into the connecting piece
of the hard-floor brush until it engages.
Press on the locking collar and pull out the telescop-
ic tube to disconnect.
Cleaning the hard-floor brush
16*
Figure
a) Vacuum from below to clean the brushes.
b)Cut through threads and hairs wound round the
rollers using scissors.
Vacuum threads and hairs with the crevice nozzle.
17
Figure
You can use the parking aid on the back of the vacu-
um cleaner if you wish to stop vacuuming for a short
time.
Once you have switched off the vacuum cleaner,
slide the hook on the floor tool into the recess on
the rear of the appliance.
All manuals and user guides at all-guides.com
Figure

When the work is done

Figure
Figure
You have purchased a floor vacuum cleaner which can
vacuum up any type of dry dirt using the dust contain-
er or dust bag.
We recommend that you use:
– the dust container, particularly for DIY-related clean-
– the dust bag principally for everyday household
Using the dust container
Figure
Figure

Emptying the dust container

Figure
18
The appliance can also be carried using the carrying
handle when vacuuming steps, for example.
19
Unplug the vacuum cleaner.
Tug the power cord briefly and let go. The cable
then rewinds automatically.
20
To store or transport the vacuum cleaner, use the
storage aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the
catch on the floor tool into the groove on the under-
side of the appliance.
ing, e.g. to vacuum up wood shavings, etc.
cleaning.
21
For the optimum vacuuming results, turn the control
knob to bagless.
We recommend that you reduce the power setting
only when vacuuming very delicate materials.
22
If the dust container is full or blocked, or the con-
tainer filter system very dirty, the filter status indica-
tor flashes red and the blue indicator goes out.
If the appliance is not switched off, and the contain-
er is not emptied or the filter system not cleaned,
after a short time, the filter status indicator will
switch to red permanently and the appliance will
automatically be switched to the lowest power level.
It will only be possible to alter the power level again
after switching the appliance off and back on
23
The dust container should be emptied after each use
or, at the latest, when the filter status indicator
flashes red with the nozzle lifted from the floor.
Open the dust bag container lid by moving the dust
container locking lever in the direction of the arrow.
11