Intended Use; Safety Informations - BGS technic 8839 Manual Del Usuario

Engine Timing Tool Set for Audi 2.8 / 3.0 TFSi
TOOLS
1 Crankshaft Locking Pin,
to be used as OEM T40069
2 Camshaft Locking Tool,
to be used as OEM T40133
3 Chain Tensioner Locking Tool,
to be used as OEM T40071
4 Counter Holding Tool for Camshaft Adjuster,
to be used as OEM T10172
5 Pins for Counter Holding Tool (4x),
to be used as OEM T10172/2
6 Pin Wrench, to be used as OEM 3212
7 Adapter for Crankshaft Pulley Bolt,
to be used as OEM T40058
8 Special Socket, to be used as OEM T10035

INTENDED USE

This tool set is made for checking and adjusting the engine timing on chain driven Audi 2.8 / 3.0 TFSi
petrol direct injection engines with variable valve adjuster, built in e.g. Audi A6.
More information regarding this item and a list of suitable engines and models can be found on our
website: www.bgstechnic.com

SAFETY INFORMATIONS

•
Do not use the tool if parts are missing or damaged.
•
Use the tool for the intended purpose only.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Be careful when working on running engines. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
•
Keep children and other unauthorized persons away from the work area.
•
Do not allow children to play with the tool or its packaging.
•
Be careful when working on hot engines because of the risk of burn injuries.
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
•
After repair or before starting the engine, turn a minimum of 2 turns by hand and check the
timing again.
•
Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
•
Do not use locking tools for camshaft and crankshaft as a counter-holder, during loosening or
tightening screws on pulleys, camshafts or crankshafts. This can damage tools and engine
components. Only use tools that are suitable for this purpose.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 8839
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed