TOOLS
1
Sensor gear alignment tool, to be used as OEM 11 9 350
2
Screw for camshaft locking tool, to be used as OEM 11 9 293
3
Inlet camshaft locking tool, to be used as OEM 11 9 292
4
Exhaust camshaft locking tool, to be used as OEM 11 9 291
5
Timing chain pre-tensioning tool, to be used as OEM 11 9 340
6
Flywheel locking pin, to be used as OEM 11 5 120
7
Camshaft alignment tool, to be used as OEM 11 9 270
8
Crankshaft locking pin, to be used as OEM 11 9 190
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool set is used for checking and setting the engine timing and the vanos unit on BMW engines
N42 / N46 / N46T.
More information regarding this item and a list of suitable engines and models can be found on our
website:
www.bgstechnic.com
SAFETY INFORMATIONS
•
Keep children and other persons away from the working area.
•
Do not allow children to play with this tool or its packaging.
•
Do not use the tool if parts are missing or damaged.
•
Use the tool for the intended purpose only.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Be careful when working on running engines. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
•
Be careful when working on hot engines because of the risk of burn injuries!.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Engine Timing Tool Set
for BMW N42 / N46 / N46T
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 8834
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed