Troubleshooting - Bosch TAS 65 Serie Instrucciones De Uso

32

Troubleshooting

Problem
Appliance not working;
no symbols light up.
I can't read the LC-
display because it is in
the wrong language.
O Automatic mod e
not working , applianc e
re m ains in stand - b y
mod e .
O Automatic mod e
skippe d , applianc e
g o e s straig h t to
N M a nual mod e .
M o re C u stome r S e r vic e inf o rmation is availab l e online at www. t assi
Robert Bosch Hausgeräte GmbH
TAS 65_85 EU 090618.indd 32
All manuals and user guides at all-guides.com
The following table provides solutions for problems and glit
that may arise as you use your TASSIMO machine. If you do not
ind a solution for your speciic problem, or the problem persists
! Note :
If piercing unit is missing, it may be purchased from
TASSIM O careline 08 00 032 88 33 or at www.tassimo.com.
Possible cause
There is no power supply.
You may want to change the
language setting.
The loat in the water tank is
No T D I S C inse r te d .
T h e b a rc o d e c o uld not b e
d e t e c t e d .
T h e b a rc o d e c o uld not b e
d e t e c t e d .
Solution
Check that the appliance is
properly plugged into the
power supply.
Please proceed as described
in the section "Controls and
ensure the loat can move.
C h e c k if T D I S C h a s b e e n
inse r te d .
C l e a n th e b a r c o d e re a d i ng
wind o w and try ag a in or
smooth th e b a rc o d e on th e
T D I S C out with your th u mb .
U s e anoth e r T D I S C .
I f prob l e m s pe r sist c o ntac t th e
T A S S I M O c a re l ine .
0 8 0 0 0 3 2 8 8 3 3 .
C l e a n th e b a r c o d e re a d i ng
wind o w.
U s e anoth e r T D I S C .
Y o u c a n still pre p are th e d r ink
b y h o ld i ng d o wn th e start / s top
b u tton.
mo. c o m
en
ches
19.06.2009 08:26:08