Troubleshooting - Bosch TASSIMO TAS 451xUC Instrucciones De Uso

EN

Troubleshooting

Problem
no symbols light up.
Machine brews but no
O
Automatic mode
remains in stand-by
mode.
O
Automatic mode
goes straight to
N
Manual mode.
More Customer Service information is available online at www.tassimo.com
TAS45 USA 090724.indd 15
All manuals and user guides at all-guides.com
The following table provides solutions for problems and
glitches that may arise as you use your TASSIMO machine.
problem persists after troubleshooting please contact TASSIMO
Customer Service at 1-877-TDISCS1 (1-877-834-7271).
!
Note: If piercing unit is missing,
it may be purchased from TASSIMO
or Bosch Customer Service Department
at 1-877-TDISCS1 or only in the USA on www.tassimo.com.
Possible cause
There is no power supply.
during the brewing process or
there is air in the system.
No T DISC inserted.
The barcode could not be
detected.
The barcode could not be
detected.
Solution
properly plugged into the
power supply.
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
inserted.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact
TASSIMO Customer Service
Department at 1-877-
TDISCS1.
Clean the bar code reading
window.
Use another T DISC.
by holding down the start /stop
button.
15
7/2009
24.07.2009 11:23:05