Please Read First - SMA Sunny Boy 1100E Instrucciones De Instalación

Sunny Boy 1100E
Quick Installation Guide
S W R
P h o to
P h o to
Sunny Boy 1100E Technical Data
Input voltage range V PV :
Max. input current I PVmax :
Nominal output power P ACnom :
To commission the Sunny Boy please make sure:
1. The Sunny Boy may only be commissioned by qualified
personnel.
2. Follow the order below when establishing the electrical
connection!
3. Check the open circuit voltage of the PV strings. Voltages
above 400 V can cause non-repairable damage!
4. Check the Sunny Boy for any transport damage.
Order for commissioning:
1. Disconnect the AC circuit the Sunny Boy is connected to
(open the circuit breaker in the AC house distribution).
2. Install the Sunny Boy (see page 2).
3. Check the PV open circuit voltage and the connection of
the PV strings.
1 1 0 0
B e tr ie
b
E
O p e
v o lt a ra ti o
ik -S tr
n
v o lt a
in g w
ic st ri
e c h se
E rd sc
n g in
lr ic h
h lu ss
v e rt e te r E a rt h
r
F a u lt
S tö ru
n g
F a il u
re
139 V - 400 V
1000 W
Output voltage range V AC :
10 A Frequency range f AC :
Weight:
5. Do not open the Sunny Boy when it is connected to the
grid.
6. Never disconnect the Sunny Boy from the PV voltage be-
fore the AC voltage has been disconnected (remove the
fuse in the house distribution). Pulling the Multi-Contact
plug connectors while under load results in an electric
arc in the connector which consequently has to be re-
placed.
4. Assemble the AC plug (see page 3).
5. Connect the AC plug.
6. Connect the AC voltage
(close the house distribution circuit breaker).

Please read first

The following instructions for
installation will help you to
commission the Sunny Boy
1100E. They do not replace
the Sunny Boy 1100E
Manual. You will find a com-
plete description of all func-
tions as well as information
on communication equip-
ment and all definable pa-
rameters in the Sunny Boy
1100E Technical Description.
198 V - 251 V
49.8 - 50.2 Hz
approx. 21 kg