How To Start Your Pressure Washer; Important - Troy-Bilt 020295 Manual Del Operario

How to Start Your Pressure Washer

To start your pressure washer for the first time, follow these
instructions step-by-step. This starting information also applies
if you have let the pressure washer sit idle for at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.7 gallons per minute (14 liters per minute) and no
less than 20 PSI (1.38 BARS) at pressure washer end
of garden hose. DO NOT siphon supply water.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See Assembly section.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer
pump.
NOTICE
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Turn ON water, point spray gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
6. Attach nozzle extension to spray gun. Tighten by hand.
7. Engage trigger lock (A) on spray gun trigger.
8. Move throttle lever (A) to "Fast"
here as a rabbit.
A
To start the engine for the very first time:
9. Push primer bulb (B) firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
9. Press primer bulb (B) firmly 3 times, waiting 2 seconds
between each push. For a warm engine, DO NOT press
primer bulb.
All manuals and user guides at all-guides.com
IMPORTANT: Before starting the pressure washer, be sure
you are wearing adequate safety goggles.
• Always wear safety goggles when using this equipment or in
• Before starting the pressure washer, be sure you are wearing
• NEVER substitute safety glasses for safety goggles.
10. When starting engine, position yourself as
A
11. Return starter grip handle slowly. DO NOT let rope
position, shown
• NEVER pull starter cord without first relieving spray gun
B
• When starting engine, pull cord slowly until resistance is felt
• After each starting attempt, where engine fails to run, always
• Firmly grasp spray gun with both hands when using high
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
vicinity of where equipment is in use.
adequate safety goggles.
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine.
"snap back" against starter.
WARNING
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
pressure.
and then pull rapidly to avoid kickback.
point spray gun in safe direction and squeeze spray gun trigger
to release high pressure. Engage spray gun trigger lock.
pressure spray to avoid injury when spray gun kicks back.
11