AVS Electronics FOGGY 30 Manual De Instrucciones página 32

Mounting FOGGY 30
Verify that package has been
positioned in the correct direction
before opening the package.
E
N
G
For correct positioning of FOGGY 30 either
at wall or at roof, use the drilling plan supplied.
Mark the holes according to preferred
installation, keeping as reference the position
of the two big holes for cables passing
FORARE QUI
(A)
ALTO (installazione verticale a parete)
LATO SINISTRO (installazione orizzontale a parete)
Once the equipment is
unpacked remove the two
M6x10 screws and remove
front cover
(B)
(A)
FORARE QUI
PARETE / SOFFITTO/CONTROSOFFITTO : (A)
Disconnect the cable of the Liquid Sensor from the F. SENSOR in
the management board.
Remove 4 screws M4x6 holding the fluid tank
Remove the tank in order to avoid liquid leakage during the
installations phases.
(A)
(B)
(A)
(A)
To ease the roof installation it is
recommended to plug on the roof
proper hanging hooks to hang the
FOGGY30 by the two special eyelets
indicated in the figure. This simplifies
the wiring and connections before
fixing the device to the roof.
- 32 -
(B)
(A)
FORARE QUI
ALTO (installazione verticale a parete)
LATO SINISTRO (installazione orizzontale a parete)
PARETE / SOFFITTO/CONTROSOFFITTO : (A)
ASOLE PER GANCI CON OCCHIOLO APERTO
(per ausilio durante installazione - vedi Manuale Installatore) : (B)
(C) FORI PREDISPOSTI PER PASSAGGIO CAVI: (C)
(C)
IST0811V1.1 PIANO FORATURA FOGGY 30
Dimensioni: 358 x 264 mm
(B)
(A)
FORARE QUI
(A)