Peg-Perego Pliko P3 Pramette Instrucciones De Uso página 20

fasten the safety belt (1). Grip the handles (2)
and help the second child climb onto the footrest
(3). Never leave your children unattended. Do not
allow the child to climb onto the rear footrest
when the stroller is empty.
STROLLER-BABY CARRIAGE
26• Pliko P3-Pramette is the new stroller with a baby
carriage incorporated. With a flick of your hand,
you can turn the stroller into a baby carriage, and
back again.
• The hood, thanks to its reversible attachment
system, can also be installed on the part by the
handles when in the stroller version (A) or on the
part opposite the handles when in the carriage
version (B). Before removing the hood to turn it
around, close it and bring it right forward to rotate
the fasteners, then detach it and reinstall it on the
opposite part; you can even rotate the fasteners
with your hands.
• The hood comes with a zipper, to make it easy to
attach products from our accessory line, such as
the rain canopy and the mosquito netting.
• The Pliko P3-Pramette cover can be mounted on
the same side as the footboard for the stroller
version (A), and on the same side as the backrest
for the baby carriage version (B).
VERSION "A" - STROLLER (PLIKO P3)
27• To mount the hood on the stroller, place it on
the same side as the handles and push the tabs
downwards, as shown in the figure. (Turn the
hood attachment to adjust it for mounting the
hood on the stroller).
28• To extend the hood, push the brace downwards.
The hood can be reclined along with the backrest.
29• To mount the cover, zip it onto the footboard as
shown in the figure.
REMOVING THE HOOD
30• To remove the hood, you must unbutton it from
the stroller, loosen the couplings and raise the
tabs of the fasteners, pushing towards the inside
of the stroller.
VERSION "B" - BABY CARRIAGE (PRAMETTE)
31• To turn the stroller into a baby carriage,
remove the hood and the cover if they have
been mounted. Lift the footboard to its highest
position. Place the front bar in the second
position, and make sure the safety belts are
attached to the backrest by inserting the tab
through the special holder in the sack.
32• Unbutton the tab buttons, as indicated in the
figure from the backrest sack and lower as
indicated in figure.
33• Unzip the two zippers found on the top of the
backrest and fold the sack as indicated in the figure.
34• Unite the sack zipper and the footboard zipper,
encompassing the front bar and arrange the sack
as indicated in the figure.
35• Lower the backrest completely, and lift the tab as
shown in the figure. The bassinet part of the baby
carriage is now ready.
36• Mount the hood on the opposite side from the
handles, by pushing the tabs downward as shown
in the figure. (Turn the hood attachment to adjust
it for mounting the hood on the stroller),
37• and button it under the footboard, as indicated in
the figure.
38• Attach the hood to the backrest and button it at
the sides, as shown in the figure.
RAIN CANOPY
39• To mount the rain canopy, zip it onto the hood.
40• The figure shows the rain canopy on the stroller
version of Pramette.
41• The figure shows where to fasten the rain canopy
All manuals and user guides at all-guides.com
42• The figure shows the lowered rain canopy on
43• This rain canopy is also designed for use when the
44• The figure shows the rain canopy on the carriage
45• The figure shows where to fasten the rain canopy
46• The figure shows the lowered rain canopy on
47• The stroller can be closed with one hand: pull first
48• Grip the central handle and pull it upward until it
49• Verify the correct closing of the stroller from the
50• Pliko P3-Pramette can be closed while the hood
51• The stroller can easily be carried (lock the
52• You can also use the side handle to carry it, as
53• To remove the strollerʼs lining, loosen the
54• Unbutton the sack at the side, as shown in the
55• Unscrew the strap (only on one side) as shown in
56• Unbutton the sack from the seat, and slip it off the
57• Slip the sack off the side of the backrest, as shown
58• Slip the previously loosened strap through the slit
59• Remove the sack and wash it, following the
The Ganciomatic System is the swift, practical
button and elastic band on the Pramette stroller
version.
the stroller version of Pramette (when the zip is
open the elastic loops ensure that the rain canopy
remains fastened to the stroller).
Primo Viaggio car seat is hooked onto the stroller,
ensuring total protection.
version of Pramette.
button and elastic band on the Pramette carriage
version.
the carriage version of Pramette (when the zip is
open the elastic loops ensure that the rain canopy
remains fastened to the stroller).
• Do not use the rain canopy indoors and always
check to be sure that your child is not too hot.
• Do not place the PVC rain canopy near sources of
heat and pay attention to cigarettes.
• Verify that the rain canopy cannot interfere with
any moving mechanism of the chassis or stroller.
• Always remove the rain canopy before closing
your chassis or stroller.
• Wash with a sponge and soapy water without
using any detergent.
CLOSING
Before closing the stroller, loosen the braces if
the hood is attached, and raise the backrest if it is
lowered.
one lever up and then the other until it releases.
closes, as shown in the figure.
safety hook. The folded stroller can stand upright.
and cover are mounted, both in the stroller and
the baby carriage version. When closed, the hood
will be on the top and the cover on the bottom for
the stroller version (A), and the cover will be on
the top and the hood on the bottom for the baby
carriage version (B).
TRANSPORT
swivelling front wheels) by gripping the central
handle, as shown in the figure.
shown in the figure.
REMOVABLE LINING
fasteners on the armrests as shown by the arrows.
figure. Slip the leg divider on the safety belt out
from under the seat.
the figure, holding your finger under the nut.
hooks on the footboard.
in the figure.
in the sack, as shown in the figure.
instructions given here.
• To remount the sack on the stroller, carry out the
instructions in the reverse order, making sure to
screw the strap back into place.
GANCIOMATIC SYSTEM