Inserting The Batteries - LaserLiner AutoCross-Laser 2 XP Manual Del Usuario

AutoCross-Laser 2 XP / AutoCross-Laser 2 XPG

Inserting the batteries

1
Open the battery compartment (2)
and insert the batteries in accordance
with the installation symbols, ensuring
the correct polarity.
Horizontal and vertical levelling
2
Release the transport restraint, set the ON/OFF switch to „ON". The laser
cross and laser points appear. The laser lines and the laser points can be
switched individually with the selection button.
LASER
The transport restraint must be released for horizontal and vertical
levelling. The laser lines flash and a signal sounds as soon as the
!
device is outside the automatic levelling range of 3°. Position the
device such that it is within the levelling range. The light of the
laser lines is constant again.
LASER LASER LASER LASER
–
+
+ –
LASER
13
GB