Inserting The Batteries; Technical Data - LaserLiner AutoCross Laser ACL 2 Manual De Instrucciones

AutoCross Laser ACL 2

Inserting the batteries

Open the battery compartment (1) and insert the
batteries in accordance with the installation symbols,
ensuring the correct polarity. Close the cover.
Switch on
Switch the unit on. A cross line will be projected.
RX-Ready
This unit can be equipped with an optional Laser
receiver. With the laser receiver the laser lines can be
seen under all light conditions until a max. range of
50 m.
Note: If the device is positioned too much out of level
(more than 3° or 6°), the laser will blink and an
acoustic warning signal will sound. Position the device
on a more level surface.

Technical Data

Automatic levelling
range
Accuracy
Operating range (depending on
room illumination)
Power supply
laser wavelength
Laser class
Weight
Operating temperature
Storage temperature
Optional:
Working range Laserreceiver
Subject to technical changes without
notice
Note:
Regularly check the calibration before use, after
transport and after extended periods of storage.
10
side-side
forward-backward
ENGLISH
+ 3°
+ 6°
+ 3 mm / 10 m
20 m
3 x 1,5V AA /
ca. 48 h
635 nm
2M / < 5mW
0,5 kg
0°C to +50°C
-10°C to
+ 70°C
max. 50 m
11/2006