Milwaukee PFH 20 E Instrucciones De Uso página 4

Tool removal 4.
Positioning the
auxiliary handle
Setting the
depth gauge
Switching over
drilling
hammer drilling
3
ENGLISH
All manuals and user guides at all-guides.com
Pull back plastic ring in direction of arrow
and remove bit.
The auxiliary handle can be rotated in
steps of 30°. Make sure that the handle is
locked in position at the chuck drive.
For drilling the required depth, insert the
depth gauge into the provided boring in the
handel and fasten it at the required drilling
depth.
Hammer-drilling:
Switch to this position . . . .
Drilling without hammer:
Switch to this position . . .
To help the lever lock into position twist the
inserted bit slightly while turning lever.
Do not switch when the machine is under
load.
During no-load operation the pneumatic
hammer mechanism is not yet activated
even if the hammer mechanism is switched on. To activate the pneumatic hammer
mechanism all you have to do is to firmly push the running machine against the
work material. This unlocks the snap die from the safety device, and drilling with
light pressure is now possible.
Only switch over when the machine is stationary or slowing down.
Only operate the machine rotating to the right when hammer-drilling
When using the adaptors always turn the hammer function off.
1
2
PFH 20 E, PFH 20 QE, PFH 24 QE