Milwaukee PFH 20 E Instrucciones De Uso página 5

Switching
between forward
and reverse
rotation
Mains
connection
Quik–Lok power
supply cable
(only applicable
for
PFH 20 QE
PFH 24 QE)
On-/off switch
4
ENGLISH
All manuals and user guides at all-guides.com
Move the lever to the required symbol:
Forward rotation . . . . . .
(Drilling / Screwing)
Reverse rotation . . . . .
Due to a lockout mechanism, the reversing
lever can only be switched when the
On-/off switch is not depressed.
Only change direction of rotation when the machine
has stopped.
Only operate the machine rotating to the right when hammer-drilling
Connect only to a single-phase AC current supply and only to the mains voltage
specified on the rating plate. Connection to sockets without earth protection is
possible as the appliance features protective insulation to DIN 57 740/ VDE 0740
and CEE 20. Radio suppression complies with the European standard EN 55014.
When fitting the plug, make sure that the brown (live) wire of this appliance is
connected to the plug terminal marked L or coloured red, and the blue (neutral) wire
of this appliance is connected to the plug terminal marked N or coloured black.
Under no circumstances must the wires of this appliance be connected to the earth
terminal of the plug marked either E, with the earth symbol or coloured green or
green/yellow.
Insert the Quik–Lok power supply cable
such that the lug of the plug grasps the
relief of the socket. After inserting lock by
turning clockwise.
Intermittent use
Switching on: Press On-/off switch
Switching off: Release On-/off switch
Continuous use
Switching on: Press the On-/off switch and
then the locking button, after that release
on-off switch.
Switching off: Press the On-/off switch and
then release.
The speed can be infinitely varied by
slowly releasing/pressing the switch
trigger.
1
PFH 20 E, PFH 20 QE, PFH 24 QE
2