Electric Shock - Abicor Binzel CR1000 Instructivo De Servicio

All manuals and user guides at all-guides.com
CR1000/CR1250
Fault Cause
• Connectors loose
• Hoses kinked
• Coolant pump defective
Leakage
• Cooling liquid temperature too high
Tab. 9 Troubleshooting
11 Disassembly
DANGER
Risk of injury due to unexpected start-up
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Disconnect all electrical connections.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Please observe the operating instructions for the welding components and welding torch.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-14.
DANGER

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
BAL.0351.0 • 2018-08-15
Solution
• Check for dirt
• Retighten clamp points
• Check hose guides, correct if necessary
• Replace hoses
• Replace the defective component
• Contact the service team
• Clean the cooling unit
• Check the fan is functioning correctly
11 Disassembly
EN - 17