Putting Out Of Operation; Maintenance And Cleaning; Electric Shock; Weekly Cleaning - Abicor Binzel BRS-LC Instructivo De Servicio

7 Putting out of operation

7 Putting out of operation
NOTE
• As the BRS-LC maintenance station is integrated into a welding system, putting out of operation
1 Switch off the robot control.

8 Maintenance and cleaning

Scheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation. In doing
so, observe the following:
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair work, the following instructions
must be adhered to:
• Interrupt the power supply
• Interrupt the compressed-air supply.

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are standard values and refer to single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified and trained specialists.
• Always wear your personal protective clothing when performing maintenance and cleaning work.

8.1 Weekly cleaning

1 Check the condition of the milling cutter.
2 Clean the clamping unit or the milling cutter.
3 Grease cutter guide after approx. 10,000 cuts.

8.1.1 Changing the cutter

The service life of the cutter depends on the filler materials used.
1 Unscrew the retaining plate and lubricating nipple.
2 Unscrew and replace the cutters.
3 Screw on the retaining plate again.
4 Check the fixed jaws for wear; reverse or replace if necessary.

8.2 Monthly cleaning

A monthly basic cleaning is recommended, and necessary in case of extreme working conditions.
EN - 15
depends on the robot control system. Please make sure that the shutdown procedures for all
components integrated in the welding system are strictly observed.
DANGER
DANGER
BRS-LC