Horizon Global 76336 Instrucciones De Instalación página 6

4. Trim fascia tabs – Locate the (4) plastic fascia tabs at the rear, remove
the plastic rivets that attach the tab to the metal bracket. Trim the plastic
tab to clear room for the hitch.
6. Remove plugs - Remove plastic and rubber plugs from bottom of both frame
rails. Return to owner. NOTE: Make sure that vehicle weldnuts are free from
rust and debris and remove excess caulk if needed.
©2020 Horizon Global Americas Inc. - Printed in Mexico
5. Remove tow hooks– Remove tow hooks from each frame rail (if present) and
return hooks and fasteners to vehicle owner.
7. Raise hitch into position - Be careful not to pinch hoses on the outside of
the passenger side frame rail or scratch fascia. Align hitch into position over
existing weldnuts as shown and install M12 bolts and conical washers (Teeth
side toward hitch) to bottom of frame rails. Note: Existing fascia tab should be
reinstalled between frame rail and bracket.
Sheet 6 of 30 76336NP 06-18-20 Rev. A