Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio página 49

_RV-HD-STANDARD.book Seite 49 Montag, 28. November 2005 3:46 15
PerfectView
Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
Ensure that you can lay the connection cables to the monitor.
When mounting the camera, proceed as follows:
➤ Mount the monitor bracket (8 3, page 5) on the monitor.
➤ Position the monitor and the attached monitor bracket for testing.
➤ Mark the outlines of the corners of the monitor bracket on the dashboard.
➤ Unscrew the monitor from the monitor bracket.
➤ Hold the monitor bracket within the outlines marked beforehand and mark
four different drilling points (j, page 9).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
IIf you would like to screw the camera on with self-tapping screws (r,
page 11):
The bracket may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 4 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the monitor bracket on with the 5 x 20 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (s, page 11):
Ensure that the nuts cannot be pulled through the dashboard
when they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 5.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M5 x 20 mm threaded screws.
All manuals and user guides at all-guides.com
Installing the rear view system
49