Mounting The Camera - Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio

_RV-HD-STANDARD.book Seite 52 Montag, 28. November 2005 3:46 15
Installing the rear view system
The following abbreviations for the colour coding of the connection cables
are used:
or
Orange Red
➤ Connect the connection cable as follows:
– Connect the red cable to terminal 15 (ignition +).
– Connect the black cable to terminal 31 (earth –).
– Connect the orange cable to the positive terminal of the reversing light.
– Connect the white cable to the positive terminal of the instrument
panel illumination.
✓ The monitor is ready for use again.
8.3

Mounting the camera

If installing the camera alters the vehicle height or length specified
in the vehicle documents, your vehicle must be inspected by the
appropriate authorities.
Make sure that you are in possession of documents verifying that
your vehicle has passed this inspection.
Warning!
Select a location for the camera and attach it so securely that
it cannot under any circumstances fall off and injure bystanders
(e.g. by being knocked off by branches brushing over the roof of
the vehicle).
Observe the following installation instructions:
To provide a suitable viewing angle, the camera must be attached at
a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting
the camera.
Ensure that the installation location of the camera is sufficiently firm
(e.g. to prevent the camera from being knocked down by branches that
may brush over the roof of the vehicle).
Mount the camera horizontally and in the middle of the rear of the vehicle
(p, page 11).
52
All manuals and user guides at all-guides.com
rt sw
Black
ws
White
PerfectView