Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio página 50

_RV-HD-STANDARD.book Seite 50 Montag, 28. November 2005 3:46 15
Installing the rear view system
Creating a through-hole for the monitor connection cable (m, page 9)
If possible, use available openings, such as ventilation grilles,
panel edges or blank panels to feed the connection cables
through. If there are no existing openings, you must drill a
hole with a 13 mm diameter. Check beforehand that there is
sufficient room for the drill head to come out on the other side.
➤ Drill two holes of Ø 13 mm near the monitor.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Connecting the monitor to the voltage supply
➤ Insert the plug of the system cable into the C1 socket (0 1, page 6)
on the monitor (m A, page 9).
➤ Insert the plug of the connection cable into the POWER socket (0 8, page 6)
on the monitor (m B, page 9).
➤ Lay the system cable under the dashboard.
➤ Lay the system cable (8 9, page 5) from the monitor to the site where
you would like to mount the camera.
➤ Attach the cables securely in the vehicles to prevent tripping hazards.
Use cable straps, insulating tape or glue.
Note
Additional extension cables are available on request
("Accessories" chapter on page 42).
50
All manuals and user guides at all-guides.com
PerfectView