Electric Start Wiring; Battery Kit Parts List - DeWalt DXGN14000 Manual Del Usuario

ELECTRIC START WIRING

The generator is equipped with electric start. An
"Off-On-Start" rotary key switch is provided on the engine. All
necessary wiring is provided. See engine manual for wiring
diagram (3A Charge Coil), and additional information.
DC FEATURES
The charging system of the unit is supplied by the
starter/alternator of the engine. 12 volts DC is constantly
charging the battery when the unit is running . Disconnecting
the battery will stop the charging of the battery.
Before charging a storage battery, check the electrolyte
fluid level in all the cells. (Sealed batteries do not require
checking). Add distilled water to each cell if necessary, to
bring the level back up to the manufacturer's required level.
off EXPLOSIVE hydrogen gas while charging.
Do not allow smoking, open flames, sparks,
or spark producing equipment in the area
while charging.
is comprised of sulfuric acid that can be very
dangerous and cause severe burns. Do not
allow this fluid to contact eyes, skin, clothing,
etc. If contact or spillage does occur, flush
the area with water immediately.
system is intended to recharge weak
batteries, not to "boost start" vehicles. Do
not overcharge battery or leave battery
unattended.
charge a battery that becomes hot or is fully
charged.
BATTERY INSTALLATION
D WALT recommends a 12 V battery with at least 235
E
cranking amps, Model U1L, Lawn and Garden Battery.
D WALT part number: DXGN035BT (0064318)
E
1. Remove battery heat shield by loosening the four M6
screws (item F).
2. Place the battery in the position provided.
3. Place the bolts through the holes on the battery pan.
4. Place the bolts through the loops on the Hold-Down
bracket.
5. Place the spacers and washers on the bolts.
6. Tighten down the Hold-Down assembly with the 1/4-20
nuts provided.
7. Reinstall battery heat shield.
Note: Spacers may be removed depending on the battery
height.
4
Storage batteries give
Battery electrolyte fluid
This battery charging
Do not continue to
BATTERY HEAT SHIELD:
Inspect to ensure that all heat shields and heat deflectors
are intact and in place. Removing or modifying parts could
cause serious damage to the battery.
sulfuric acid (when filled). May contain
explosive gasses. Always abide by safety
warnings provided with the battery.
- Keep sparks, flame and cigarettes away.
- Hydrogen gas is generated during
charging and discharging.
- Always shield eyes, protect skin and
clothing when working near batteries.
Connect the red 8 ga. battery lead to the positive (+)
battery post and the black 8 ga. battery to the negative (-)
battery post with the bolts and nuts provided.

BATTERY KIT PARTS LIST

Item P/N Description
A. 0035170 Bolt, 1/4-20 X 8"
B. 0003723 Washer 1/4
C. 0047796 Spacer
D. 0036525.02 Hold Down bar
E. 0052758 Wing nut, 1/4-20
Batteries contain
Qty.
2
2
2
1
2
English