Caller Id Display; Set Up Mode; Feature Set Up - Clarity Power 440 Guia Del Usuario

PM080404_C440_RevB_E#34CA7F.qxd

CALLER ID DISPLAY

Set-up Mode
C440 handset goes into setup mode automat-
ic when battery is connected.
Or press and hold MODE button for 3 sec-
onds to enter setup mode. If there is no input
within 30 seconds, the language will be set
to the last selected one and go back to stand-
by mode.
Caller ID Screen
Setting Language
1. After entering setup mode, the LCD
display will show SEL LANGUAGE
and then 1.ENG 2.SPA
alternately with a tick mark against
the selected language.
2. Press 1 OR 2 button once to change
the language. The tick mark will move
against the new selection.
3. Press UP ( ) to go to the next menu.
▲
12
All manuals and user guides at all-guides.com
8/14/04 15:08 Page 12
Feature Set-up
Setting Contrast
There are 3 contrast levels and the default is
set to level 2.
1. After setting the language, press UP(
key to begin setting contrast.
2. The LCD display will show LCD
CONTRAST and 1 2 3.
3. Press the 1, 2 or 3 key to change the
level. The current selected level will be
highlighted.
4. Press the UP( ) or DOWN (
▲
to go to the next menu.
Setting AREA CODE 1
1. After setting Contrast, press UP (
button to set Area Code 1.
2. The LCD display will show "AREA CODE
1 and XYZ with X digit blinking.
3. Enter the area code number using the
numeric keys on the handset.
4. Press the UP ( ) or DOWN (
▲
go to the next menu.
Setting AREA CODE 2
1. After setting Area Code 1, press UP (
button to set Area Code 2.
2. The LCD display will show AREA CODE
2 and XYZ with X digit blinking.
3. Enter the area code number using the
numeric keys on the handset.
4. Press the UP ( ) or DOWN (
▲
to go to the next menu.
)
▲
) button
▼
)
▲
) button to
▼
)
▲
) button
▼