Callback From Caller Id Information - Clarity Power 440 Guia Del Usuario

PM080404_C440_RevB_E#34CA7F.qxd
CALLBACK FROM CALLER ID
INFORMATION
To callback from incoming call information,
the base T/P switch should be set at T.
While reviewing the incoming call list, press
ENTER and the UP( ) or DOWN (
▲
will format the number with the following
dialing variations:
7 digits without a 1 prefix:
If the area code of the Caller ID number
matches to the setting of the stored area
code, the dialed numbers can be 7
digits only.
Area Code + 7 digits without a 1 prefix:
If the area code of the Caller ID number
matches to the setting of the stored area
code, the dialed numbers can be Area Code
+ 7 digits.
10 digits without a 1 prefix:
If the area code of the Caller ID number is
different from the stored area code, the
dialed numbers can be 10 digits without
a 1 prefix.
10 digits with a 1 prefix:
If the area code of the Caller ID number is
different from the stored area code, the
dialed numbers can be 1 + 10 digits.
All manuals and user guides at all-guides.com
8/14/04 15:08 Page 23
Caller ID Operations
) key
▼
When reviewing the Caller ID information,
press ENTER to display the phone number in
a different format.
Example 1:
Stored Long Distance Service code: 1.
Stored area code: 770.
Stored incoming call number 770-123-4567.
1. Pressing the ENTER key will show
blinking 123-4567.
2. Pressing the TALK or ENTER key
again will dial out 1234567.
OR
3. Pressing the UP ( ) key will show
▲
blinking 770-123-4567. Then press
the TALK or ENTER key again will
dial out 7701234567.
OR
4. Pressing the UP( ) key will show
▲
blinking 1-7701234567. Press the
TALK or ENTER key will dial out
17701234567.
OR
5. Pressing the UP ( ) key will show
▲
blinking 123-4567 again.
E
N
G
L
I
S
H
23