Ordering accessories
To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your Philips
dealer. You can also contact the Philips Consumer Care Center in your country.
When you order spare teats, make sure that you use a teat with the correct flow rate for your baby
(see 'Choosing the right teat for your baby') and do not mix Philips Avent Anti-colic bottle parts and
teats with parts of the Philips Avent Natural bottles. They do not fit and could cause leakage or other
issues.
Recycling
- Do not throw away the product with the normal household waste at the end of its life, but hand it
in at an official collection point for recycling. By doing this, you help to preserve the environment.
- This product contains a built-in rechargeable battery which shall not be disposed of with normal
household waste. Please take your product to an official collection point or a Philips service center
to have a professional remove the rechargeable battery.
- Follow your country's rules for the separate collection of electrical and electronic products and
rechargeable batteries. Correct disposal helps prevent negative consequences for the environment
and human health.
Battery removal instructions
- When you handle batteries, make sure that your hands, the product and the batteries are dry.
- To prevent batteries from heating up or releasing toxic or hazardous substances, do not modify,
pierce or damage products and batteries and do not disassemble, short-circuit, overcharge or
reverse charge batteries.
- To avoid accidental short-circuiting of batteries after removal, do not let battery terminals come
into contact with metal objects (e.g. coins, hairpins, rings). Do not wrap batteries in aluminum foil.
Tape battery terminals or put batteries in a plastic bag before you discard them.
- If batteries are damaged or leaking, avoid contact with the skin or eyes. If this occurs, immediately
rinse well with water and seek medical care.
Note: Only remove the rechargeable battery when you discard the product. Before
you remove the battery, make sure that the product is disconnected from the wall socket
and that the battery is completely empty.
Note: Take any necessary safety precautions when you handle tools to open the
product and when you dispose of the rechargeable battery.
1. Remove the rubber
feet from the bottom of
the motor unit.
2. Remove the screw
with a torx screwdriver.
3. Open the motor unit
by pressing at the sides
of the device.
English
4. Disconnect the
connectors from the
printed circuit board.
23