Charging The Breast Pump; Battery Indicator Light Description; Assembling The Breast Pump - Philips AVENT SCF394 Manual Del Usuario

English
14

Charging the breast pump

Fully charge the battery before you use the breast pump for the first time and when the battery is low.
Fully charging the battery takes up to 4 hours.
3 sec.
1. Switch off the device.

Battery indicator light description

All lights are
steady on. The
battery is fully
charged.
Charged battery
operates
approximately
3 pumping
sessions.*
* One session is the equivalent of 15 minutes (double electric breast pump) or 30 minutes (single
electric breast pump).

Assembling the breast pump

Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with
milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
2. Insert the adapter
into the wall socket and
insert the small plug at
the other end into the
motor unit.
Two lights are
steady on.
The battery is
charged
sufficiently for
maximum two
sessions.*
3. The battery is
charging.
First light flashes
slowly.
The battery is
charged
sufficiently for
maximum one
session.*
4. When the battery is
fully charged, remove
the adapter from the
wall socket and pull the
small plug out of the
motor unit.
First light flashes
quickly.
The battery is very
low, the device will
soon stop
operating,
charging is
needed.
Battery lights light
up one by one and
go out all together.
The battery is
charging.