Slime SMART SPAIR PLUS Manual Del Usuario página 2

CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING • PLACE INFLATOR ON
A HARD, CLEAN SURFACE. WEAR GLOVES AND SAFETY GLASSES WHILE OPERATING
INFLATOR.
1. Check your tire warranty prior to installation of this product.
2. DO NOT run vehicle while inflator is operating. You may need to be in "accessory" or "on"
position. Please make sure emergency brake is set and car is in park. Always ensure air hose chuck
touches the core of the valve stem for proper inflation.
3. DO NOT use inflator continuously for more than 12 minutes. Allow unit to cool approximately 25
minutes between uses. Do not leave inflator unattended.
4. ALWAYS use a pressure gauge to check tire pressure. DO NOT overinflate.
5. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings. Be careful
not to inflate items beyond their capacity.
6. While operating, never block the inflator input or output.
7. Keep inflator out of reach of children.
8. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older 8 amp
cigarette lighter receptacles.
WARNING!
This repair kit is only suitable for emergency tire repairs to enable vehicles to be driven to a service
center where proper repairs can be made to the tire. Not intended for use for major tire damage.
Radial ply passenger car tires may only be repaired in the tread area. No repairs are permitted on the
bead, sidewall, or shoulder area of the tire. To prevent injury extreme caution should be used while
using tools. Eye protection should be worn while repairing tire.
INFLATOR INSTRUCTIONS
1. Push air hose valve connector on the valve stem.
2. Close thumb latch connector to secure the valve.
3. Plug power cord into 12 volt accessory power outlet.
4. Turn inflator on. Inflate tire to manufacturer's recommended air pressure. Correct tire
pressure can be found in vehicle's owner manual or on driver's side door jamb.
5. Unplug power cord and remove air hose connector.
USING THE ADAPTERS
PULL UP TO
UNLOCK
PUSH DOWN
TO LOCK
HOW MUCH SEALANT PER TIRE?
To unlock the hammerhead valve,
pull handle upward, then place in
adapter and push down to lock
in adapter.
14 oz. (414 mL)