Battery Charger; Intended Use - Surtek AR436 Manual De Usuario

rays for extended periods, temperatures above
50°C cause damage.
• Do not dispose of the power tool or the bat-
tery into household waste, fire or water.
• Hold the power tool securely: When tighten-
ing or releasing screws, high reaction torque
can briefly occur.
• Perfect operation of the machine is only able
to ensure if the original accessories intended
for it are used.
• When working in high altitude, make sure to
put on the wrist band.

BATTERY CHARGER

• Store the unit in a dry and frost-free place.
• The voltage of the power source must agree
with the value given on the nameplate of the
machine. The unit must not be damp and must
not be used in a wet environment.
• Do not carry or hang up the unit by the
cable.Before each use of the unit, check the
cable and plug. If damage is detected, do not
use the unit. Have repairs performed only by
a qualified technician. Never open the unit
yourself.
• As the battery charger heats up during charg-
ing, the unit must not be operated on easily
inflammable surfaces (ej. paper, textiles, etc.)
or in combustible environments.

INTENDED USE

The unit is intended to drive in and loosen
screws, to drill small holes in wood.
Before Putting into Operation
Charging Batteries (see Fig. 1 & 2)
The battery charger supplied is matched to
the Li-ion battery. Do not use another battery
charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protec-
tive circuit: The tool holder no longer rotates.
CAUTION: Pressing the on/off switch too
much can damage the Li-ion battery.
There are two charging
ways:
1. Insert the power plug
of the device into the
socket (up to 120 V). In-
sert the DC output plug
into the charger base.
6
Put the screwdriver on the charger base.
2. Insert the power plug of the device into the
socket (up to 120 V). Insert the DC output plug
directly into the screwdriver.
When the red bat-
tery indicator on the
screwdriver lights up
which indicates the
battery is charging.
When the red bat-
tery indicator turns to
green, it indicates the battery is fully charged.
NOTE: When you begin to charge, please make
sure the red battery indicator on the scrwedriv-
er lights up otherwise the screwdriver may not
connect well with the charger or the charger
base.
During the charging procedure, the handle of
the machine warms up. This is normal.When
not using for extended periods, disconnect the
battery charger from the socket.
Let the screwdriver charge initially for 10
hours. After the initial charge, under normal
use, a charge of 5 to 7 hours is adequate.
Protect the Charger from Moisture!
CAUTION: The battery used in this device
may present a fire or chemical burn hazard if
miscreated. Do not disassemble, heat above
50˚C (122˚F) or incinerate.
Accessories: This tool cames with the next bits:
Titanium bits with 1/4"
hex shank: 1/16", 3/32",
1/8".
2" Bits;
Phillips: #1(2), #2(3).
Torx: T10, T20.
Standard: #3-4, #5-6, #8-10.
Changing the tool
• Use magnetic holder when the screwdriver
bit is 25 mm (see Fig.C)
• Insert the screwdriver bit that are not shorter
than 50 mm directly into the tool holder 2.
Initial OperationChanging the rotational direc-
tion switch.
OPERATION
1. Push the "Forward Direction" rotational di-
rection switch to the stop, to cause the screw-