Troubleshooting - Yeedi DVX34 Manual De Instrucciones

5. Troubleshooting/5.1 Troubleshooting
No. Malfunction
Robot is not able to connect to
1
the home Wi-Fi network.
2 Robot is not charging.
28
EN
Possible Causes
Incorrect home Wi-Fi username or password
entered.
Robot is not within range of your home Wi-Fi
signal.
Network setup started before Robot was
ready.
Robot is not switched ON.
Robot has not connected to the Self-empty
Station.
The Power Cord is not connected to the Self-
empty Station.
The battery is completely discharged.
Make sure the Self-empty Station is
connected to the power supply.
Solutions
Enter the correct home Wi-Fi username and password.
Make sure Robot is within range of your home Wi-Fi
signal.
Turn ON Power Switch. Press the RESET Button for 3
seconds. Robot is ready for network setup when it plays
a musical tune and its Wi-Fi Indicator light flashes slowly.
Switch ON Robot.
Be sure that the robot's Charging Contacts have
connected to the Self-empty Station Pins.
Make sure the Power Cord is firmly connected to the
Self-empty Station.
Re-activate the battery. Switch ON. Place Robot on the
Self-empty Station by hand, remove after charging for 3
minutes, repeat 3 times; then charge normally.
The Self-empty Station is not connected to the power
supply.