Activating The Info Mode; Activating The Quick Menu; Menu Navigation - Dräger Polytron 8100 Instrucciones De Uso

4.3

Activating the Info mode

No password required.
The Info mode is used to show instrument relevant information.
This will not interrupt the normal operation of the instrument.
Tap and hold [UP] for more than 3 seconds.

The instrument information is shown on several screens.
No changes can be made.
Tap [UP] / [DOWN] to switch between the screens.

The Info mode can be exited at any time by tapping [OK].

If no key is tapped within 30 seconds, the instrument will

automatically return to normal operation.
Example of the Info mode
Depending on sensor the screens may vary:
1. Screen - Instrument information:
07.11.2003 12:34
SW Version : XX
Part No. : 8317778
Serial No. : ARUA0001
DeviceCode: 00006317
1/3
Instrument Info
A001.eps
Date and Time

Software version

Part number of the instrument electronics

Serial number of the instrument electronics

Instrument code

2. Screen - Sensor information:
Sensorname: O
2
Part No. : 6809630
Serial No. : XXXXXXX
EEPROM Typ : 1
EEPROM Vers.: 1
2/3
Sensor Info
A002.eps
Installed sensor

Part number of the sensor

Serial number of the sensor

Software version

Software revision

Dräger Polytron 8100
3. Screen - Sensor configuration:
Gasname : O
2
Range : 25.00 Vo
4–20 SP : 25.00 Vo
Alarm A1 : 19.00 Vo
Alarm A2 : 23.00 Vo
3/3
Sensor Config.
A003.eps
Selected gas

Maximum measuring range and units for the sensor

Measuring range and units for the analog interface. Only

shown if the 4 to 20 mA interface is enabled.
A1 Alarm set point and units

A2 Alarm set point and units

4.4

Activating the Quick Menu

No password required.
Tap and hold [DOWN] for 1 to 2 seconds.

The selected information about status or instrument
settings can be retrieved (e.g. warning messages, error
messages, installed modules and calibration data, time/
concentration graph, see Section 5.8.5 on Page 23.
No changes can be made.
4.5

Menu navigation

Scrolls upwards
Sets values
Scrolls downwards
Sets values
Confirms entry
Selects menus and functions
NOTICE
i i
The instrument is designed for the magnetic wand
(part number 4544101: blue body, white logo) to be
used with the enclosure lid in place. If the enclosure lid
is not in place, the magnetic wand may activate two or
more buttons at once (cross-talk).
Operation
15