AirPro PROGRESS LIGHTING P250072 Manual De Instalación página 12

Installing the Light Kit
Pan/Light Kit Fitter
Assembly/ Glass Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 15)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads fit into the keyhole slots. Turn the
light kit pan clockwise, tightened the
screws. Re-install the screw that was
removed in step 1 and tighten firmly.
(Figure 15)
3. Remove one screw from the light kit pan
and loosen, but do not remove the other
two screws. Connect the wires from the
light kit fitter assembly to the wires from
the fan motor assembly by connecting the
molded adaptor plugs together. Carefully
tuck all wires and splices into the switch
cap. (Figure 16)
9.
4. Push the light kit fitter assembly up so
that the two loosened screw heads fit into
the keyhole slots. Turn the light kit fitter
assembly clockwise, tighten the screws.
Re-install the screw that was removed in
step 3 and tighten firmly. (Figure 16)
5. Place the light shade into the light kit pan,
aligning the three flat areas on the top
of the light shade with the three raised
dimples in the light kit pan. Turn the light
shade clockwise until it stops. (Figure 17)
PERIODICALLY CHECK THE LIGHT SHADE IS
SEATED FULLY CLOCKWISEL LIGHT KIT PAN
ASSEMBLY.
Motor
Assembly
Light Kit
Pan
Screws
Light Kit
Pan
Light Kit
Fitter
Assembly
Screws
Flat
Area
Light
Shade
Figure 15
Blue
White
Black
Figure 16
Raised
Dimples
Figure 17