Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Focus E2 31806 Serie Modo De Empleo/Instrucciones De Montaje



Safety Notes

Gloves should be worn during installation to prevent

crushing and cutting injuries.
The hot and cold supplies must be of equal

pressures.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.

English

Symbol description

max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 31
To adjust the hot water limiter on single lever
mixers, please see page 32. No adjustment
is necessary when using a continuous flow
water heater.
Do not use silicone containing acetic acid!
Dimensions (see page 33)

Flow diagram

(see page 33)
Spare parts (see page 36)
Operation (see page 34)
Cleaning see enclosed brochure
Test certificate (see page 35)