Bosch Professional GCM 10 SD Manual Original página 50

50 | English
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the
52°
standard mitre angles of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
38°
Settings
Vertical bevel angle
Ceiling strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Outer corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
1 609 929 X04 | (13/7/10)
Placed
against
the fence
0°
Left side Right side
45° right
Bottom edge Bottom edge
against the against the
fence
... to the right ... to the left of
of the cut
45° left 45° right
Bottom edge Bottom edge
against the against the
fence
... to the right ... to the left of
of the cut
Lying flat
on the
saw table
52°
Left side
45° left 31.6° right
Upper edge
against the
fence fence
... to the left of
the cut the cut
31.6° left
Bottom edge
against the
fence fence
... to the right
the cut of the cut
33,9°
Right side
31.6° left
Bottom edge
against the
fence
... to the left of
the cut
31.6° right
Upper edge
against the
fence
... to the right
of the cut
Bosch Power Tools