Care And Maintenance - KENMORE ELITE 630.7793 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE TASKS
Certain areas of your dishwasher require occasional
maintenance. The maintenance tasks are easy to do and
will ensure continued superior performance from your
dishwasher:
Wiping up Spills and Splash-outs
Water may occasionally splash out of your dishwasher,
especially if you interrupt a cycle or open the dishwasher
door during a cycle. To avoid floor damage and possible
mold growth, do not allow wet areas to remain around or
under the dishwasher.
Clean the Stainless Steel Inner Door and Tub
Clean the outer edges of the inside door panel regularly
to remove debris that might collect from normal loading.
If spots begin to appear on the stainless steel tub or inner
door, make sure the rinse agent reservoir is full.
Check and clean the Spray arm nozzles
Occasionally check the spray arms to ensure that the spray
arm nozzles (holes) are unobstructed. You must remove the
spray arms to check them for obstruction.
To remove the top spray arm:
1. Remove the empty top rack from the dishwasher.
2. Turn the rack upside down. The top spray arm is held
in position by a locking nut as shown above. Turn the
locking nut counter-clockwise and remove it as shown
above to release the spray arm.
3. Remove the spray arm as shown above.
4. Look for obstruction in the spray nozzles.
5. If the spray nozzles need cleaning, flush them under
running water.
All manuals and user guides at all-guides.com

CARE AND MAINTENANCE

To reinstall the top spray arm:
1. Return the top spray arm to its installed position.
2. Return the locking nut to its installed position and turn it
3. Return the top rack to the top rack roller guides.
To avoid injury, do not reach into the large object trap
with your fingers. The large object trap could contain sharp
objects.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the dishwasher
2. Grasp and lift the bottom spray arm as shown below.
3. Look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, flush them under
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed position
2. Return the bottom rack to its installed position.
This dishwasher has a filter system that consists of a Large
Object Trap/Cylinder Filter assembly and a Fine Filter.
The filter system is located on the inside of your dishwasher
under the lower rack and is easily accessible. During
normal use, the filter system is self-cleaning. You should
occasionally inspect it for foreign objects and clean it when
necessary.
15
1/8 turn clockwise.
CAUTION
tub.
running water.
and press it so that it snaps into place.
Check and clean the filter system

Publicidad

Tabla de contenido
loading

Tabla de contenido