Control Panel; Icons Description - omi ESD Serie Manual Del Operador

6.0 CONTROL PANEL

The machines in this series are equipped with an electronic controller for the adjustment of the operating parameters. Adjustments can
be made using the digital panel, located on the dryer's front panel. Please note that the SET POINT & other control parameters
have been optimized and factory set. Although the set point value can be displayed, the ability to alter these factory settings
via the digital interface on the front panel has been removed to eliminate the possibility of unit damage caused by improper
settings.
Normal conditions read - out
6.1

Icons description

ICON
Cod. 710.0159.01.00 Rev01 – 10.2012
fig.1 - Control panel
At normal operating conditions, if no alarms are present, the upper display shows the DEW
POINT temperature, the lower display shows the AMBIENT TEMPERATURE.
Led (dryer ON) is lighting.
icon (refrig. compressor ON) and
At energy saving condition, if no alarms are present, the upper display shows the DEW POINT
temperature, the lower display shows cyclingly ESA for 10sec and the AMBIENT
TEMPERATURE for 1sec.
Led (dryer ON) is lighting.
icon (circulator ON) is lighting.
DESCRIPTION
Generic Alarm
High / Low refrigerant discharge pressure Alarm (HP/LP)
Icon ON shows "Celsius degrees"
Icon OFF shows "Fahrenheit degrees"
Refrigerant compressor energized
(Blinking when start refrigerant compressor delay activated)
"Functions menu" activated
Icon connected to time parameters
(ON when in Functions or Programmation area)
Circulator energized
icon (circulator ON) are lighting.
8 - 106