Grounding Instructions - vitapur VWD2636W-3 Manual De Uso Y Cuidado

GROUNDING INSTRUCTIONS

• Improper use of the grounding plug can result in a risk of electric shock causing serious injury, even death.
• This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
• This appliance is equipped with a power cord having a grounding wire with a grounding plug and must be
connected into a properly grounded polarized outlet. Consult a qualified electrician if the grounding instructions
are not completely understood, or if doubt exists as to whether the appliance is properly grounded. If the wall outlet
is a standard 2 prong outlet, it is your personal responsibility and obligation to have it replaced with a properly
grounded 3-prong wall outlet.
• Do not under any circumstances cut or remove the third (ground) prong from the power cord plug.
• Do not use an adapter plug with this appliance.
• Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician install
an electrical outlet near the appliance.
YOUR vITAPUR WATER DISPENSER
®
1. Bottle support collar
2. Ready-To-Dispense indicator lights:
Yellow: "flashing"
"off"
Blue: "on"
"off"
3. Kettle Feature (on/off) activation button (self-illuminated)
"flashing" Heater (hot water tank) is operational.
"on" The hot water has reached optimum temperature and is ready for dispensing.
"off" Heater (hot water tank) is off, however remaining water within the tank may still be very hot, always
exercise caution when dispensing and/or draining water from the hot water tank.
4. Hot water push button (also dispenses room temperature
water when Kettle Feature is not activated)
5. Child resistant safety switch
6. Cold water push button
7. Removable drip tray
8. Hot water drain valve (bottom of dispenser)
9. Cold water drain valve (bottom of dispenser)
All manuals and user guides at all-guides.com
Low water level inside internal reservoir. Hot water heating system cannot be activated.
(you must replenish water supply)
Internal reservoir water level is sufficient to activate hot water heating system
The cold water has reached optimum temperature and is ready for dispensing
The cooling cycle is in progress, it is possible to dispense water during the cooling cycle,
however, optimum cooling temperature may not yet be achieved.
8
bottom of dispenser
1
3
4
5
9
2
2
6
7