vitapur VWD2636W-3 Manual De Uso Y Cuidado página 5

1. Unplug the unit, and remove the water bottle.
2. Remove the bottle support collar and check the water level inside the
reservoir – it should be at roughly 4cm / 1.5" from the bottom.
3. Closely monitor the water level inside the reservoir, (1-2 hours) if the
water level drops, immediately drain the remaining water from the unit and
call customer service at 1-866-253-0447. If the water level remains constant
it is the water bottle not the dispenser that is leaking. Please contact your
water supplier for a replacement bottle.
Please visit us at www.greenwayhp.com for water dispenser accessories and
helpful use and care tips.
Air Pockets
During the initial water filling of your dispenser, air pockets can become entrapped inside water carrying components,(
i.e. water tanks & water lines ) this condition, is normal and unavoidable. To facilitate removal of the trapped air pockets,
simply push and hold the water taps/buttons down (open) for approximately 1 minute to purge (bleed) entrapped air from
the system. This action should not have to be repeated on subsequent water fills.
Dispensing Room and Cold Water
Place a glass under the spigot. For cold water, press the
dispensed. Before the Kettle Feature is activated, the
room water, press the
Dispensing Hot Water).
Temperature Setting
The water temperatures (hot and cold) are factory set and cannot be adjusted.
Dispensing Hot Water
The hot water (Kettle Feature) dispensing system on this unit is designed to save energy and money. Conventional hot
water dispensing systems operate 24/7 regardless of water usage. The (on demand) Kettle Feature activates the hot water
system "only" when the Kettle Feature button is activated delivering steaming hot water in less than 3 minutes.
To dispense hot water, first press the Kettle Feature activation button. The red indicator button will begin flashing to
indicate that the water heater is active. In approximately 3 minutes the set temperature point will be reached and the red
light will stop flashing and remain on. The water is now ready to be dispensed; press down on the
desired amount of water is dispensed, then release the button. If water is not immediately dispensed, the water will begin
to cool and the red light will shut off, requiring you to initiate another cycle.
To deactivate the Kettle Feature during a heating cycle, simply press the red button again.
All manuals and user guides at all-guides.com
button downward until the desired amount of water is dispensed (for hot water, see
button downward until the desired amount of water is
button dispenses room temperature water. To dispense
4
2.a
2.b
Water Level
button until the