Adding Water - Vornado EVHUM Manual Del Propietário

All manuals and user guides at all-guides.com
Filling & Installing the Water Reservoir
This Humidifier has a 2 gallon capacity and 3 gallon output in 24 hours. When it needs
refilling, follow these simple instructions: Unplug the Humidifier. Be sure the Humidifier is
placed on a firm, flat and level surface (we recommend the floor). As with any water filled
appliance, spills can occur, so be careful when filling and installing the Water Reservoir, and
cleaning or moving the Humidifier.

ADDING WATER

Remove the Water Reservoir by grasping the recessed handle on the top of the Reservoir (A).
Lift and pull upward (B). Turn the Reservoir upside down. Remove the Cap assembly (C).
If refilling the Reservoir, dump out any water left inside the Reservoir prior to refilling. Place
the Reservoir in the sink upside down. The top of the Reservoir has a flat surface that can
stand by itself during the fill operation. Fill the Reservoir with cool tap water (D). Once filled,
insure the Gasket is in position and reassemble the Cap assembly. Some downward pressure
may be needed to compress the Gasket prior to rotating the Cap assembly 1/4 turn clock-
wise to the fully installed position.
A B
C D
INSTALLING THE WATER RESERVOIR
Lower the Reservoir into the Base, positioning the fill port over the raised bump. The bump
will activate the water outlet valve inside the Cap once in a nested position. Insure the Reser-
voir is setting firmly in the Base.
4