PRESIDENT TAYLOR FCC 12V Manual Del Usuario página 8

SCAN function activated (the dot blinks)
Indicates the selected channel
WX mode activated
Indicates frequency or menu
6) CB/PA ~ CB TB
3-position switch : CB, CB TB and PA.
CB/PA
CB PA
Switch between and (Public Address) mode.
An external optional speaker can be connected to the unit to the PA.SP. jack
on the rear panel. (D). LCD indicates
mode "AM".
For more details on operating in PA mode, see the PA SETTING menu on
page 11.
CB TB
The central position of the switch allows the activation of the TALKBACK
function.
TALKBACK function
This function allows you to hear
optional external speaker connected to the EXT jack. MS. (C).
When activated, LCD shows the TALKBACK level during 3 seconds.
TALKBACK level
When the function is activated, press and hold the PTT switch (13) then turn
the rotary CH knob (3) to increase
the volume level of the TALKBACK from 1 to 9. Release the PTT switch (13).
7) NB/ANL - HI-CUT FILTERS
3-position switch: Low position: no filter is activated. Central position: only
ANL and NB filters are enabled. High position: all filters (ANL, NB and HI-CUT)
are activated.
NB: Noise Blanker / ANL: Automatic Noise Limiter. These filters allow reducing
back ground noises and some reception interferences.
HI-CUT: Cuts out the high frequency interferences and has to be used in
accordance with the reception conditions.
PA
mode by blinking the modulation
your own modulation in the internal or
(clockwise) / decrease (counterclockwise)
8) EMERGENCY CHANNELS
Emergency channels will be automatically
(8). 3-position switch: EMG1/ Emergency channel 1 is activated. EMG2 /
Emergency channel 2 is activated. OFF / No emergency channel is acti-
vated.
The default emergency channels are channel 9 (EMG1) and channel 19
(EMG2).
See the EMG SET 1 and EMG SET 2 menus page 11 to
channels.
Note: Activating an emergency channel prevents the SCAN function or
PA mode. If the KEY BEEP function is activated, an error beep
activating the
sounds. "EMG" and the channel blink to indicate unauthorized handling.
Put the switch (8) to the OFF position to use these functions.
9) F ~ VOX
F
(short press)
Enter MENU. See § MENU page 9.
VOX
(long press)
The VOX function allows transmitting
phone (or in the optional vox microphone) without pressing the PTT switch
(13). The use of an optional vox microphone connected to the rear panel
of the transceiver (E) disables
Long press on the VOX key (9) in order to
appears on the display. Long press again on the VOX key (9) to
function. "VOX" disappears.
See menu VOX SETTING on page 11.
10) WX MODE ~ ALERT
WX MODE
(short press)
CB
Note: functions except SCAN deactivate the
Select first a channel other than the EMG1 or EMG2. The EMERGENCY CHAN-
NEL switch (8) must be in the central OFF position. Press briefly the WX key
(10) to alternate between
WX
"WX" is displayed. mode allows you to listen to weather reports. When
this mode is turned on, turn the rotary CH knob (3) or use the UP/DN (14)
keys on the microphone to search, through the 7 weather channels, for the
channel corresponding to your location (See WEATHER FREQUENCY TABLE
page 54).
8
selected
by switching this key
set
by speaking into the original micro-
the original microphone.
activate the VOX function. "VOX"
WX
mode .
CB WX WX
and modes. When mode is active,
emergency
disable
the