Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
internal loudspeaker [or external optional loudspeaker connected to jack
EXT.SP (C)]. "AM" blinks on the LCD.
OF: The reception is no more functional. Only the
phone
is transmitted to the Public Address loudspeaker connected to jack
PA
PA.SP. (D). PA and
volume level are displayed.
PA: the
modulation of the microphone
ted to the Public Address loudspeaker connected to jack PA.SP. (D). The
used modulation mode "AM" blinks on the LCD.
The VOL knob (1) allows adjust
Default PA setting is: I n.
See § CB/PA (Public Address) page 8.
10) MIC TYPE
The PRESIDENT TAYLOR FCC 12/24 V can be used with an electret micro-
phone as well as with the dynamic one, 6-pin PRESIDENT (see the cabling
diagram page 55). Turning on the unit, the type of the microphone is
briefly displayed.
Press the F key (9) to
enter
MENU.
1.
Turn the rotary CH knob (3) or use UP/DN keys (14) on the microphone to
select
the MICTP function.
2.
Press the F key (9) to
validate.
3.
Turn the rotary CH knob (3) or use UP/DN keys (14) on the microphone to
select
the type on the microphone EL (electret) or DY (dynamic).
4.
New press on the F key (9) to validate. The parameter stops blinking. a)
Go to point 1 to
adjust
another function or b) Press the PTT switch (13) to
validate
and
exit
MENU.
disappears.
5.
exits
If no key is pressed, the unit
the display.
Default type of microphone is EL (electret).
11) RESET
Restores all factory settings.
Press the F key (9) to
enter
MENU.
1.
Turn the rotary CH knob (3) or use UP/DN keys (14) on the microphone to
select
the RESET function.
2.
Press the F key (9) to
validate.
3.
New press on the F key (9) to reset. The unit
4.
exits
If no key is pressed, the unit
modulation of the micro-
and the
received signal
are transmit-
PA
volume.
is displayed.
The current parameter blinks on LCD.
MENU after 10 seconds,
disappears from
is displayed.
AL blinks on LCD.
exits
MENU.
disappears.
MENU after 10 seconds.
disappears
D) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency range
- Weather channels
- Antenna impedance
- Power supply
- Dimensions
- Weight
- Accessories supplied
2)
TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity
- Drain
- Modulated signal distortion
3)
RECEPTION
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
12
: 40
: AM
: from 26.965 MHz to 27.405 MHz
: from162.400 MHz to 162.550 MHz
: 50 ohms
: 13.8 V / 27.6 V
: 5.905 (W) x 6.496 (D) x 1.771 (H) inches
150 (W) x 165 (D) x 45 (H) mm
: ± 1.653 lbs / 0.750 kg
: 1 microphone electret UP/DOWN with
support, mounting cradle, screws and
fused power cord.
: +/- 200 Hz
: 4 W
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz
: 3.0 mV
: < 2 A @ 13.8 V / <1.5 A @ 27.6 V
: 2 %
: 0.5 µV - 113 dBm
: 300 Hz to 3 kHz
: 60 dB
: 3 W
: minimum 0.2 µV - 120 dBm
: maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 150 ~ 500 mA (13.8 V)
100 ~ 300 mA (27.6 V)
Publicidad
Tabla de contenido
