Tips On Measurement - Powerfix Profi HG03064B Instrucciones De Utilización Y De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
the pencil
pencil hole of the product.

Tips on measurement


 
T he PUSH button
during the entire search process (calibration
and search).
 
I f you calibrate too closely to the object or di-
rectly on the object, the calibration can fail. If
the calibration fails, the LC display shows the
full intensity (Fig. C) and a long beeping tone
sounds or can't search any object in the wall.
Move and hold the product several centimeters
further to the right or left of the previous surface
and recalibrate. Start the search process.
 
R epeat several times to ensure the detection
accuracy.
 
I ncorrect measurements can occur depending
on the nature of the examined wall. Check
therefore before every measurement the posi-
tion of a known wooden or metal beam, of a
known void or a known power line. If these
are not detected by the product, the substrate
is not suitable for a search with this product.
 
A void touching the LC display during meas-
urements as it may affect the accuracy of the
product.
 
P lease note that power lines can also be lo-
cated as metal or as beams. Always use the
additional voltage search, so that you can
exclude any incorrect interpretations.
 
P lease note that metal beams are also detected
in the Beam search „STUD" function. If you
find a beam and you want to be sure that it is
26 GB/IE
into the intended slot into the
4
must remain pressed
5

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido