Remote Signalling Alarm; Electronic Drain Discharge; Maintenance - omi ED Serie Manual De Instrucciones

s.r.l. s.r.l.
s.r.l. s.r.l.
Activation of the above function is on User's discretion. The User will purchase all necessary
installation material by himself. Any operation which needs access to the dryer must be carried out
by qualified personnel.

6.10.2 Remote signalling alarm

The dryer control board is supplied completely with a digital output configured as remote signalling alarm. This digital output is
controlled by a relay configured as normally open: when an alarm is detected, this relay closes a circuit. The status of the relay can
be inverted, if necessary, using AL18 programming parameter (See 6.6.2 Parameters table).
Proceed as follows to activate a remote alarm output:
1. The User must provide a signaller in compliance to output relay electrical features (solenoid coil, light bulb, acoustic
signaller, ...).
2. Disconnect the dryer from electrical feeding and open the electrical box.
3. Connect the signaller on "REMOTE ALARM" terminal blocks (See electric wiring diagram – wires 25 and 26).
Activation of the above function is on User's discretion. The User will purchase all necessary
installation material by himself. Any operation which needs access to the dryer must be carried out
by qualified personnel.
Alarm Output relays electric features:
Voltage on User's discretion
max. current 3A
7.0 ELECTRONIC CONDENSATE DRAIN

7.1 Maintenance

•
Close the ball valve located on the filter/stop installed at the drain trap inlet.
•
Depressurize the trap by pushing the TEST button on the control panel.
•
Unscrew the plug in the end of the filter/stop to access the filter screen (F) and
clean it with a compressed air jet.
•
Reassemble and open filter/stop valve.
29/89
(F)
Cod. 710.0103.01.01 – Rev.3B – 03.2012
ED – DXL AL ED ED ED
Cleaning of the drain solenoid valve
serie