Infrared Remote Control (Optional) - Cameo CLQS40TW Manual De Usuario

INFRARED REMOTE CONTROL (optional)

Activate the infrared remote control in system settings (Menu Settings) under "IR remote" (IR Remote On). Aim the infrared re-
mote control directly at the infrared sensor built into the front of the spotlight. The maximum range is approximately 8 metres.
BL/ON/OFF (Blackout)
The BL button is used to switch off the LED in the spotlight, regardless of operating mode. Press the BL button again to reactivate the
previously selected mode.
SP/SPEED
Without function.
/ BRIGHTNESS
12 brightness settings. Press the button then select the desired brightness using the + and - buttons (level 1= blackout).
FL/FLASH (Strobe)
Activate the strobe effect and set one of its 14 speeds. Press the FL button, then use the + and - buttons to select the fl ash frequency (level
1 = strobe disabled, level 2 = slowest fl ash frequency, level 14 = fastest fl ash frequency).
CW/WW (R, G, B, W, A and UV without function)
Press the button CW (cool white) or WW (warm white) then adjust the brightness of the corresponding LED to the desired level (of 12 levels)
by repeatedly pressing the + or - buttons. The LEDS are switched off at level 1.
PG
Without function.
CM
Without function.
10